Thermik Gerätebau GmbH

The thermal switch CW1 is used to protect transformers. It is recommended in all cases of an increase in temperature, due to an overload current, e.g. in case of short circuit and where resetting is n...

The switch C06 – without insulation cap - is characterized by its ability to tolerate high current load in spite of its small design. Furthermore it can be installed into windings because it is resist...

The switch S06 – with insulation cap - is characterized by its ability to tolerate high current load in spite of its small design. Furthermore it can be installed into windings because it is resistan...

This switch is designed for thermal protection of electrical devices if protection class II is required. The Ryton housing with a dielectric strength of 3750 V allows fastening to the object to be pro...

Thermal Protector P08

• normally open
• resets automatically
• with connection pins
• fully insula...

This PTC motor protector can be used in various ways, e.g. motors, transformers. It is characterized by reliability and form stability. Because of its small construction it is also usable in difficult...

General areas of application

PTC thermistors are heat-sensitive sensors whose resistance increases with temperature, and can be used in almost all areas where a digital temperature measurem...

Where possible, the PTCs are to be inserted parallel to the coil. As a result, when shaping the coil ends, the mechanical stress of the PTCs is minimised. In so doing, the Mylar®-­Nomex&reg...

All Thermik products are state of the art in terms of design, material selection and composition and are protected by numerous national and international industrial property rights. Thermik's self-...

In order to measure and control the temperature in various electronic devices (temperature protection) as part of temperature protection, we use the properties of bimetals in our temperature limite...

• Round thermal protectors
• Flat thermal protectors
• Pressure-resistant thermal protectors
• Sealed thermal protectors
• Current-independent thermal protector...

Bimetal discs are subject to an ageing process that cannot be avoided. This changes the function parameters of the discs, depending on their load capacity and life cycle. The parametric stability o...