Thermik Gerätebau GmbH

The switch mechanism of Type F1 is comprised of five primary parts:

• 1) a conductive housing,
• 2) a steel contact cover with stationary contact,
• 3) a snap-action sp...

Thermal Protector PM1

Power class: 1,6 A to 7,5 A
Type series: F1

• normally closed
• resets automatically
• with plug connections
• without i...

Temperature limiting switches of Type M1 are used for overheating protection in electric devices. Due to a new housing, a special flat design is reached. Version CM1 – with connection leads – availabl...

Temperature limiting switches of Type M1 are used for overheating protection in electric devices. Due to a new housing, a special flat design is reached. Version SM1 – with insulation cap and connecti...

The thermal protector C01 with pins is used for overheating protection of electrical devices where after overheating and subsequent cooling an automatic resetting is required. The pin version especial...

Thermal Protectors of Series 01 are used for overheating protection of electrical devices, most suitable for electrical motors whereat after overheating and subsequent cooling an automatic resetting i...

Thermal Protectors of Series 01 are used for overheating protection of electrical devices, most suitable for electrical motors whereat after overheating and subsequent cooling an automatic resetting i...

Thermal Protector Type N01 with connection pins is specifically designed for direct installation into printed circuit boards for overheating protection of heat sensitive electronic components and circ...

The switchgear of type series K1 is fixed in a positive lock and is self-aligning between the floor of a conductive housing (1) and a contact cap which is made of steel (2) and insulated from it, p...

The current sensitive thermal protector type CZ1 is used for overheating protection mostly implemented in transformers (acc. to EN 60742). It is recommended in all cases of a increase in temperature d...

The thermal switch CP1 – without insulation cap - is applied where protection against overheating is required and where an automatic reset of the device after overheating and subsequent cooling is not...

The thermal protector SP1 – with insulations cap -are applied where protection against overheating is required and where an automatic reset of the device after overheating and subsequent cooling is no...