OTEC Präzisionsfinish GmbH
22.11.2019 00:11
The special requirements of laser cut parts
Laser cut parts are used in many industries, from jewellery to automotive, electrical and optical engineering. Once manufactured, their edges are slightly burred, and the parts often suffer from unsight-ly discolouration. Much of the time, these defects are removed by hand, which is time-consuming and costly.
The challenge is almost always the same: how to deburr and polish extremely thin parts – i.e. less than 0.4 mm thick and usually made of stainless steel – without changing their geometry.
But also, during processing, how to prevent the parts from chafing against each other, or from getting wedged in the container or stuck in the gap.
Many requirements. One expert solution.
Back in 1997, OTEC launched two innovations that revolutionised mass finishing in the jewellery business:
Both of these innovations enable cost-effective, rapid and effective processing for delicate laser cut parts.
The OTEC CF Series: rapid mass finishing for very fine workpieces
Workpieces are processed in an open container that has a disc-shaped floor with a rotary bearing. They are added to the fixed container along with a suitable grinding or polishing granulate. When the disc turns, the contents are set in motion in a toroidal flow. Centrifuging the granulate and workpieces makes this process highly intensive – up to twenty times more effec-tive than conventional vibrators, for example.
OTEC’s machine technology draws on years of development expertise. Our container with zero gap system is one such example, making it possible to process very thin workpieces (< 0.4 mm) without jamming the machine. So these machine models are especially suitable for deburring, edge-rounding and polishing delicate workpieces such as laser cut parts.
The CF Series disc finishing machine is available with up to three containers, which means it can handle up to three processing steps in parallel. It also comes with various manual and automatic post-processing options for separating the abrasive from the workpieces.
All informaions about OTEC CF-Series: https://www.otec.de/en/products/mass-finishing/disc-finishing-machines/cf-standard-series/
About OTEC Präzisionsfinish
OTEC GmbH Präzisionsfinish provides precision technology for achieving perfect surfaces. OTEC machines are used for smoothing, precision edge-rounding, polish-ing and deburring a wide variety of workpieces, with the aim of improving surface quality. With a network of international business partners, OTEC has a global pres-ence. OTEC’s comprehensive, market-leading technical expertise in developing the perfect interplay of machine and abrasive benefits a wide range of industries includ-ing tooling, medical devices, jewellery, and automotive and aerospace.
Press contact
OTEC Präzisionsfinish GmbH
Heinrich-Hertz-Straße 24
75334 Straubenhardt-Conweiler Germany
Tel. + 49 (0) 70 82 - 49 11 20
Fax + 49 (0) 70 82 - 49 11 29
info@otec.de | www.otec.de
30.01.2020 01:05
Nothing makes jewellery sparkling like a uniform surface19.12.2019 01:05
Targeted precision ginding and polishing with stream finishing22.11.2019 00:00
In 5 minutes more security in space: OTEC supports researchers22.11.2019 00:00
HIGH EFFICIENCY AND PROCESS RELIABILITY WITH POLISHED MOULDS22.11.2019 00:00
PARTNERS IN INNOVATION AND TRADITION SINCE 1996: