Kaestner-Tools GmbH

Solid carbide or brazed carbide one-chip drills for drilling holes into closed plastic containers without penetration of chips inside the container. Only one single chip is produced, which is cut off...

• Disc milling cutters
• Form cutters (backed off, relief-ground)
• Coupled sets of form cutters
• Groove cutters
• Gear cutters
• Shell end mills...

• Tools for straight turning
• Form tools
• Special form inserts
• Indexable inserts
• e.g. for hard turning up to 65 HRC
• Indexable insert tools...

• with cylindrical shank
• with Morse taper shank
• without internal cooling
• with internal cooling

Example of use: Milling of a T-slot Ø16x8 in C45(rough-finished T-slot of 8 mm)

• Cutting speed: 120 m/min, 2390 rpm
• Feed rate: 570 mm/min, 0.04 mm/tooth

• Disc milling cutters
• Form cutters (backed off, relief-ground)
• Coupled sets of form cutters
• Groove cutters
• Gear cutters
• Shell end mills...

• Step countersinks and counterbores
• Form countersinks and counterbores
• Special countersinks and counterbores
• Spot facer
• Counterbores
• Pilot co...

• with cylindrical shank
• with Morse taper shank
• without internal cooling
• with internal cooling

• Disc milling cutters
• Form cutters (backed off, relief-ground)
• Coupled sets of form cutters
• Groove cutters
• Gear cutters
• Shell end mills...

• Disc milling cutters
• Form cutters (backed off, relief-ground)
• Coupled sets of form cutters
• Groove cutters
• Gear cutters
• Shell end mills...

• Shanked cutters and shank-type form cutters
• Lollipop end mills
• Torus cutters
• Keyway cutters
• T-slot cutters
• Dovetail cutters
• Corner...

• Tools for straight turning
• Form tools
• Special form inserts
• Indexable inserts
• e.g. for hard turning up to 65 HRC
• Indexable insert tools...