Gas Injection Technique (GIT) by Eisenhuth GmbH & Co. KG
Product inquiry
The main reasons for the use of the gas injection technique are the following:
- uniform filling-out of thick-walled areas without sink marks.
- reduced cooling time for thick-walled molded Parts.
- reduced filling pressure or lower number of injection points required for large thin-walled molded parts.
- production of geometries with a high torsional rigidity.
- design solutions with shapes that were previously impossible to produce by injection molding.
- low-warp combination of areas with very thick walls and areas with very thin walls on a single molding without any perceptible deterioration in surface quality.
- alternative to hollow-article blow molding.
Product inquiry